Irish Pride's latest activity

  • Irish Pride
    Sand them down(400, 800, 1500, 2000, 3000) and then polish them with a cutting compound. I like Meguiar's Ultimate Compound. Once you...
    • 20170916_094759.jpg
    • 20170916_180749.jpg
    • 20190324_142739.jpg
    • 20190324_165421.jpg
  • Irish Pride
    Irish Pride replied to the thread Oil on Spark Plug tip.
    It's possible that you have the cam sensor vane installed in the wrong position too. When the cams are set at the timing marks on the...
  • Irish Pride
    Irish Pride replied to the thread Oil on Spark Plug tip.
    To me it sounds like you have the timing off. I would remove the crank damper and pull the upper and lower timing covers and verify the...
    • unnamed (1).jpg
  • Irish Pride
    Irish Pride replied to the thread Oil on Spark Plug tip.
    I'm gonna have to start from the very beginning. I'll read thru all of the post up till now and then be back with some questions. I...
  • Irish Pride
    Irish Pride replied to the thread Decal size question.
    Sorry for the delay, I went out to check and none of my current 4 SHOs still have this decal in the window. I asked a few other SHOwners...
  • Irish Pride
    It doesn't have to be anything special. Just get some matching f lange bolts at the hardware store or off Amazon. I believe they are 8mm...
    • 20250629_171400.jpg
    • 20250629_171400(1).jpg
  • Irish Pride
    Irish Pride replied to the thread Oil on Spark Plug tip.
    The "stays" aren't even required. I've eliminated all of them from my 95. If you look at my intake the bosses are completely gone. -Chad
    • 20250421_154909.jpg
    • IMGP2036aA_28.jpg
  • Irish Pride
    Irish Pride replied to the thread Oil on Spark Plug tip.
    Install the stud thru the intake bracket and into the intake and tighten down with 19mm wrench. Next is the black wire harness...
  • Irish Pride
    Irish Pride replied to the thread Decal size question.
    Do you want the overall size of the actual decal or just the black outline within? I can take a measurement later today. -Chad
  • Irish Pride
    I will be there with Se7en parked in the featured tent. -Chad
    • FB_IMG_1774833055769.jpg
    • FB_IMG_1709078754421.jpg
  • Irish Pride
    Irish Pride replied to the thread OEM OR AFTERMARKET?.
    OEM if you can still get them which in the case of the SHO is pretty hard to come by. -Chad
  • Irish Pride
    Irish Pride replied to the thread No fuel pump whine.
    Fuel pump test. Use paperclip to jump Signal Return with Fuel Pump to cycle the pump. If it doesn't run by doing this then you need a...
    • eec-iv_testing2.gif
  • Irish Pride
    Irish Pride replied to the thread Oil on Spark Plug tip.
    The bolt goes thru the intake bracket into the head to secure the bracket. Use 19mm for that. Then the wire harness bracket goes on to...
  • Irish Pride
    Irish Pride replied to the thread White 91 on BAT.
    It was 3.2 swapped and came with some nice parts. I was very close to bidding on it just for the parts but I don't have the time to go...
  • Irish Pride
    Irish Pride replied to the thread Introduction.
    Welcome in. -Chad

Forum statistics

Threads
107,152
Messages
1,181,963
Members
16,201
Latest member
shootinirons

Members online

Back
Top