Recent content by dudev
-
Intermittent stalling
Sorry FTDP Sorry that is IAC (Idle Air Control) - not IAB- dudev
- Post #3
- Forum: Gen 1 & 2 - Engine, Exhaust, Drive Line & AC syste
-
Intermittent stalling
My $.02 Look at the battery connections. A smaller wire that branches off of the the neg terminal is very important for the computer to operate correctly. Also if you are stalling at low RPM it could be the IAB. I've seen a lot of stalling problems solved by replacing the IAB.- dudev
- Post #2
- Forum: Gen 1 & 2 - Engine, Exhaust, Drive Line & AC syste
-
Where can I get some manifold bolts?
Wow! I sure lucked out. While turining down the 12 bolts on the manifold (I was using a torque wrench at 7ft/lbs) 1 bolt twisted in half, another almost did. I got the manifold off again OK and could easily rotate out the 1 part that broke off. Strange, guess too many times in and out...- dudev
- Thread
- Replies: 4
- Forum: Gen 1 & 2 - Engine, Exhaust, Drive Line & AC syste
-
Would a bad IAB......
Thank very much for all the info. I'll let you know what happens.- dudev
- Post #15
- Forum: Gen 1 & 2 - Engine, Exhaust, Drive Line & AC syste
-
Would a bad IAB......
Hello everyone. I’ve been “lurking” on your forum for about a year and finally registered today. I have a white 93 ATX SHO with 106k. I have OK power through RPM range but it misses slightly at idle. Also it starts OK about 50% of the time – the bad times it needs the accelerator about half...- dudev
- Post #10
- Forum: Gen 1 & 2 - Engine, Exhaust, Drive Line & AC syste
