Recent content by BEEVER
-
B
fuel press? lean condition
Out of curiosity, Beever, what EEC are you using for your new 3.2L setup - ATX or MTX? Its a mtx X2J to be exact. :thumb:- BEEVER
- Post #6
- Forum: Gen 1 & 2 - Engine, Exhaust, Drive Line & AC syste
-
B
fuel press? lean condition
No c/e I can only tell by looking at the plugs- BEEVER
- Post #5
- Forum: Gen 1 & 2 - Engine, Exhaust, Drive Line & AC syste
-
B
fuel press? lean condition
:confused: Ok I am having a leaning out problem with my 93. The plugs are white and there is lots of detonation on them. I am wondering if a 155 or 190 lph pump will help me solve this problem over the stock pump?- BEEVER
- Thread
- Replies: 9
- Forum: Gen 1 & 2 - Engine, Exhaust, Drive Line & AC syste
-
B
Loud bang on take off's @ hard shifting
[ BTW what type of subframe bushings do you have in there? Stock ones? Yeah I have stock subframe mounts. Didn't get a chance to take strut rod apart yet, To much work in the garage to get in on the lift today. :dribble:- BEEVER
- Post #10
- Forum: Gen 1 & 2 - Engine, Exhaust, Drive Line & AC syste
-
B
Loud bang on take off's @ hard shifting
So I also checked the mounts and they move a little a 1" or so side to side. But this seems something other than motor mounts. And I have really no shiny spots on the intake or the hood liner. Also fluid was just changed 1000 mi back with the clutch@lightweight flywheel.- BEEVER
- Post #7
- Forum: Gen 1 & 2 - Engine, Exhaust, Drive Line & AC syste
-
B
Loud bang on take off's @ hard shifting
I rechecked the subframe with an air gun should i use a breaker bar- BEEVER
- Post #6
- Forum: Gen 1 & 2 - Engine, Exhaust, Drive Line & AC syste
-
B
Loud bang on take off's @ hard shifting
:bonk: Ok here it goes. So on take off I hear a banging noise and on hard shifts sometimes the same noise. I put it on the lift and checked the balljoints,strut rods to subframe,subframe mounts,the rack bolts. I looked at the motor mounts and seemed to be OK. Any one got any insight? :rant...- BEEVER
- Thread
- Replies: 10
- Forum: Gen 1 & 2 - Engine, Exhaust, Drive Line & AC syste
-
B
ZEX 82011 Install help
:confused: Hey man I only know one thing, with the bottle mounted to the side, your system will not work properly. It may seem like it is working well but if you mount the bottle with the the valve pointing to the front of car up at a 45 degree angle or so it will work better. I only know...- BEEVER
- Post #43
- Forum: Tuning ~ Supercharger ~ Turbo ~ Nitrous Upgrades
