Recent content by 914turboford
-
9
How much horsepower can an OEM clutch handle?
CM 3 stands for Clutch Master stage 3, right? What did you pay? Also, how does your clutch pedal feel as compared to a stock clutch? I am leery of these aftermarket clutches that provide a light pedal feel by "moving the fulcrum". Another thing, does the Clutch Master stage 3 have a cast iron...- 914turboford
- Post #46
- Forum: Gen 1 & 2 - Engine, Exhaust, Drive Line & AC syste
-
9
How much horsepower can an OEM clutch handle?
Yes, I've read the thread. No, I have not watched the video. My conclusion is that the original poster has an anomoly with his clutch. I have a Spec stage II. It is an 8.5" ****** unit. 6 puc. I think it is a piece of garbage. It does not hold as well as the JY clutch I had in the car before...- 914turboford
- Post #44
- Forum: Gen 1 & 2 - Engine, Exhaust, Drive Line & AC syste
-
9
How much horsepower can an OEM clutch handle?
Found out that a 91 SHO PP bolts to my Ranger FW which will bolt to my 2.3t. So it looks like I am good to go. I saw a Valeo in person at a NAPA parts store. They want $410 for it so I think I'll order one from the Zone. Are the PP's you guys use cast iron? This one was. At any rate, I think I...- 914turboford
- Post #42
- Forum: Gen 1 & 2 - Engine, Exhaust, Drive Line & AC syste
-
9
How much horsepower can an OEM clutch handle?
What flywheel is needed to run a 9.75"?- 914turboford
- Post #38
- Forum: Gen 1 & 2 - Engine, Exhaust, Drive Line & AC syste
-
9
How much horsepower can an OEM clutch handle?
I've got a Ford 2.3 turbo bolted up to a 1989 ****** GT MTX powering a 1973 Porsche 914. See it at Engineconversions.org if you are interested. The trans input shaft is 7/8-20, apparrently the same as a 90 SHO. I am slipping my stupid $280 Spec stage II 6 puc 8.5" ****** clutch. I want to...- 914turboford
- Post #36
- Forum: Gen 1 & 2 - Engine, Exhaust, Drive Line & AC syste
