Static/noise thru speakers

Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.

HDMCKNETT

New Member
Joined
Jul 5, 2002
Messages
6
Reaction score
0
Location
Maryland
I get a lot of static/noise through my speakers when the antenna is going up or down and when my wipers are working, loud enough to completely drown out the radio. Any suggestions? (I have a '92)
 

projectSHO89

SHOless In St L
Joined
Nov 7, 2001
Messages
6,116
Reaction score
160
Location
St. Louis, MO
Probably a bad cable from the antenna to the radio.

Is it especially bad on AM stations? Try going under a bridge or overpass while on an AM station (not too strong of one). If you then pick up alternator whine and electrical noise from the blower motor, go for the cable.

Chances are, the shield has corroded away from the ground terminal that mounts to the antenna.

Other possibility is that you have lost the ground connection at the antenna end for some other reason (usually corrosion).

Pull the radio out, unplug the antenna cable, and measure the resistance between the outside portion of the terminal to a good chassis ground. It should be a dead short. Anything over a few ohms is bad, if open, replace the cable. I used one from a junkyard SLO, cost me a buck.

Steve
 

smacd

New Member
Joined
Sep 29, 2002
Messages
40
Reaction score
0
Location
Lethbridge, Alberta
Also, check your ground connections (particularily those around the battery at the rad support) for corrosion. A bad ground could also cause interference in the radio.
 

96lt1

Likes to cut
Joined
Sep 30, 2002
Messages
310
Reaction score
0
Location
Ashland, Ohio
noise thru speakers can also be cause by too many ground points. as those ground points corrode they lose connection and start to cause static
 

projectSHO89

SHOless In St L
Joined
Nov 7, 2001
Messages
6,116
Reaction score
160
Location
St. Louis, MO
noise thru speakers can also be cause by too many ground points. as those ground points corrode they lose connection and start to cause static
Must be some kind of new math. That situation should result in LESS ground points.

Bad grounds can cause noise in audio systems because when the ground contact is lost, that lead then becomes an antenna, allowing other electricalnoise/RF signals to be picked up, rectified, and amplified.

Steve
 

rubydist

SHO Master
Staff member
Super Moderators
Joined
Jun 25, 2007
Messages
7,521
Reaction score
3,399
Location
Denver
The other place I have had issues is when the metal hood was not grounded to the chassis. Of course, fiberglass hoods would not have this problem.
 

sperold

Last to Know
Joined
Aug 25, 2008
Messages
3,753
Reaction score
1,440
Location
Ontario Canada
There is a small capacitor thing attached to the coil that suppresses noise in your audio system.

Does not explain the wiper and antennae issues in post one, but is worth a look for general interference.
 

Forum statistics

Threads
107,084
Messages
1,181,282
Members
16,152
Latest member
Satchmoz

Members online

Back
Top