todras
New Member
I replaced the rear bar with a 26mm. Big improvement BTW. I installed new bushings and endlinks too. I'm getting a clunk now. What are the endlinks supposed to be tq'ed to? What could it be? Everything looks good.
Replaced rear sway etc.???
- Thread starter todras
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
Ishodu
SHO Member
What bushings and endlinks did you install?
todras
New Member
Beats me. Just had new struts installed and they are the ones they threw on. It was fine till I messed with it.
Ishodu
SHO Member
Then they are rubber then? Just tight enough so that they start to flaten out good.
todras
New Member
Hmm I thought I went pretty tight. I guess I'll try to put some more muscle on them. I just reinstalled the opposite of removal.
todras
New Member
Well I think the culprit was the driver side sway bracket. Didn't have it tight enough. There was a 2-3mm gap. 
FWIW Ford states only 5-7 ft lbs tq for the rear end links.
FWIW Ford states only 5-7 ft lbs tq for the rear end links.
