Mike Kelly
SHO Member
Do all three rivots have to be removed for the window motor to come out? I need to go buy bolts and wanted to make sure before I went. Thanks
Gen 1 front window motor
- Thread starter Mike Kelly
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
mrecoolgar
SHO NUP
The regulator assembly is held in place with rivets.
The motor is held in place by bolts.
The motor is held in place by bolts.
Mike Kelly
SHO Member
mrecoolgar Thanks for the reply. Dont get mad I need more direction.
I assume you support the window in the door ( board, etc) and then remove the three bolts on the motor. Do you just wiggle the motor out then. I hate to screw Dad's window up more than it is . Thanks Mike
I assume you support the window in the door ( board, etc) and then remove the three bolts on the motor. Do you just wiggle the motor out then. I hate to screw Dad's window up more than it is . Thanks Mike
Similar threads
