Search results
-
0
"Many Gen 3 & Gen 2 Parts for Sale"
here's a set of mirrors made the same way, with the same components. (his don't have brakes though). The writeup on TCCA will get you signals that are barely visible with a narrow viewing angle. I had a set of those before...- 00tec-saTX
- Post #15
- Forum: SHO Parts - Classifieds
-
0
*Cringe* I think i need rod bearings
Probably not.... I haven't been under it to look (it's 600 miles away). It's a Florida/South Carolina Car so I don't think rust is going to be that much of an issue. :shrug: My dilema is, I have to drive there (to Pensacola from east Texas), replace the bearings, and drive it back, and I only...- 00tec-saTX
- Post #7
- Forum: Gen 1 & 2 - Engine, Exhaust, Drive Line & AC syste
-
0
*Cringe* I think i need rod bearings
Sorry for the hijack, but to anyone that has done the RBs, how long does it typically take? I've never been in the bottom of a motor, but I'm fairly good as a shadetree mechanic. Guessing by looking at the writeup on shophoenixproject, I was guessing 5 hours or so.- 00tec-saTX
- Post #5
- Forum: Gen 1 & 2 - Engine, Exhaust, Drive Line & AC syste
-
0
LED Tails project thread **updated** final product post 28
Ah, I see now.- 00tec-saTX
- Post #25
- Forum: Gen 1 & 2 - Wheels, Tires, Interior, Body, and Cos
-
0
LED Tails project thread **updated** final product post 28
Using the PWM allows you to run higher than nominal amperage without cooking the LED correct? If so, why not compensate for the brightness by allowing more power to the LED's? For example, with these, the nominal amperage is 40ma, but if you use a pulsed current you can use 100ma. I know the...- 00tec-saTX
- Post #22
- Forum: Gen 1 & 2 - Wheels, Tires, Interior, Body, and Cos
-
0
LED Tails project thread **updated** final product post 28
The turn/brake part of the housing is all in the same area. The housing has 3 sections, the main brake/turn area, reverse, and an extra unused spot. Does that PWM operate the LED's at their nominal voltage? I believe the superflux (phillips) I have run at 2.6v 70ma... Bright little things...- 00tec-saTX
- Post #20
- Forum: Gen 1 & 2 - Wheels, Tires, Interior, Body, and Cos
-
0
LED Tails project thread **updated** final product post 28
Been lurking for a while, I've learned that reading and paying attention does wonders rather than opening my mouth and getting flamed. We were discussing your lights on TCCA, just trying to gather how difficult it would be to complete on a G4. My SHO isn't here yet, but it may get the same...- 00tec-saTX
- Post #17
- Forum: Gen 1 & 2 - Wheels, Tires, Interior, Body, and Cos
-
0
LED Tails project thread **updated** final product post 28
If I may ask, where did you get that PWM?- 00tec-saTX
- Post #15
- Forum: Gen 1 & 2 - Wheels, Tires, Interior, Body, and Cos
