Search results
-
J
Poor performance when warm...
Well,this is an ongoing issue, unfortunately. The trouble is when my 93ATX warms up, i.e. when the temp needle hits the bottom line, the car lags, bogs, stumbles, and just dosen't perform as it should. The only code I get, after clearing, running, reading, 3 times is the 332 EGR. Is there a...- jebooker
- Thread
- Replies: 2
- Forum: Gen 1 & 2 - Engine, Exhaust, Drive Line & AC syste
-
J
Rough idle/ missing when warm (part deaux)
In my previous post, I stated that my 93 ATX was dropping 2 cylinders when warm...after pulling plugs, cleaning things etc...I found the problem. A bad connection at the coil. I started the car, and just began to giggle wires at random, then all of the sudden....it died completely. Where can...- jebooker
- Thread
- Replies: 3
- Forum: Gen 1 & 2 - Engine, Exhaust, Drive Line & AC syste
-
J
93' ATX...Dropping (2) Cylinders when warm
The saga continues...in my last post (stumbles/hesitates) I said there was a KOER code 217..Primary circuit failure, ignition coil #3. After the usual 5min run well until warm, then hesitate and run poorly routine, I did some more investigating. I listened closely and noted that there were two...- jebooker
- Thread
- Replies: 14
- Forum: Gen 1 & 2 - Engine, Exhaust, Drive Line & AC syste
-
J
93ATX Hesitates/Stumbles
Hi...My car has been acting up for about a month now...Mainly after it warms up. It is hesitating on acceleration, and idiling rough. It almost seems as if two cylinders drop out evry once in awhile. It will idle @ 800 rpm then for no apparent reason drop to 500 and be very rough until I tap...- jebooker
- Thread
- Replies: 6
- Forum: Gen 1 & 2 - Engine, Exhaust, Drive Line & AC syste
