Recent content by Sprague
-
S
EATC questions
Does anyone know if a gen II EATC will work in a gen I? Has anyone wired a hard button face to a gen I EATC? Thanks- Sprague
- Thread
- Replies: 2
- Forum: Gen 1 & 2 - Electronics & Audio
-
S
Help, New Clutch installed - Grinds going into reverse
The pedel feel is pretty close to stock and does not chatter or grab. Takeup is very smooth. Other than the reverse issue, and that is described as normal, things could not be better. Thanks to all for the helpful replies. :D- Sprague
- Post #10
- Forum: Gen 1 & 2 - Engine, Exhaust, Drive Line & AC syste
-
S
Help, New Clutch installed - Grinds going into reverse
Yes, I have driven it from the shop to home and the forward gears are fine. I know that the disk is in with the correct side to the engine. From the replies, things are normal.- Sprague
- Post #6
- Forum: Gen 1 & 2 - Engine, Exhaust, Drive Line & AC syste
-
S
Help, New Clutch installed - Grinds going into reverse
I have just finished installing a Fidanza flywheel, a South Bend Clutch Inc. TZ (kelvar) disk, pressure plate, a SHONUT ceramic throw out bearing and Synchromesh transmission fluid. The clutch has very little travel before engaging and the transmission will not go into reverse without...- Sprague
- Thread
- Replies: 10
- Forum: Gen 1 & 2 - Engine, Exhaust, Drive Line & AC syste
Latest posts
-
-
-
-
-
Finally Upgrading After 18 Months Of Ownership- Latest: Texas Marauder
Forum statistics
Staff online
-
Irish PrideIrish Inside