Recent content by sling

  1. S

    No power under load

    Sounds good, I have another Sho with a good TPS. If that doesn't work I think that I will revisit the converters, I only tested the front one.
  2. S

    No power under load

    Not Fixed So I finished the work and put the intake back together. New plug wires, same plugs, same manifold gasket. I really took my time making sure everything was put back right. There has been no change! I took it out and drove it minutes ago and as soon as there is a load put on it it...
  3. S

    No power under load

    Continued...Anybody experience this before? Thanks again in advance.
  4. S

    No power under load

    So I removed the intake, plugs and wires tonight. They won't have my replacement plug wires until tomorrow. So here are a couple of pics that I have questions about. The first are my plugs, I'm not sure if it can be made out from the pic, but the upper left one had an additional washer installed...
  5. S

    No power under load

    Norman-That is a good point. I have not dug into the car yet...no time. But, I do have a 4 day weekend stretching in front of me. I am going to be working on this tomorrow night and hopefully will have good news to report.The wires are under warranty and I was planning on swapping them out at...
  6. S

    No power under load

    Sounds like there is nothing left to do but to remove the intake manifold and reseat it. I'll begin working on that in the next couple of days. Thanks for all the input. I will also check all the plugs and wires while I am in there.
  7. S

    No power under load

    RubyDist- I followed the 60k guide on the shopheonix website and replaced all the valve cover seals, intake manifold gasket, plugs and wires. One thing that I have wondered is whether I was supposed to put some sort of sealant on the manifold gasket.
  8. S

    No power under load

    Thanks for the input. I checked the plug wire routing and it is correct. I don't see anything unplugged and I have not been able to find a vacuum leak. I bought a compression tester and hooked it up where the first O2 sensor goes and tested for backpressure and I had to really throttle up to get...
  9. S

    No power under load

    So I installed the MAF and the IAT, but there was barely any difference. Still running terrible. Idle is good still, but as soon as I begin to let off the clutch it wants to die. I have to give it a lot of gas to keep it going. I wonder if I didn't put everything back together just right during...
  10. S

    No power under load

    Sounds good... Purchased the parts and will keep you updated. Again, I appreciate the quick response.
  11. S

    No power under load

    Thanks for the quick response and the code symptom explanation. I was looking at replacing those sensors but shouldn't the codes be logged again after some more driving? I probably put another 20 miles on it seeing if it would relog those codes. I also was looking at the plug wires and found...
  12. S

    No power under load

    I have a 1990 SHO that I bought a couple years back. The car ran great up until I decided to do a tune-up and discovered oil in the plug wells. Long story short I did an upper 60k. It has never run the same. Starts and idles great... revs fine but once I start driving the car is very sluggish...
See more

Latest posts

Forum statistics

Threads
107,077
Messages
1,181,197
Members
16,142
Latest member
Kaevorlly

Members online

Total: 1,940 (members: 3, guests: 1,937)

Share this page

Back
Top