Recent content by sinkesho
-
S
NOS Rear Caliper Set 1989 - 1992
Hello Just came across this post. Are the callipers still available? Come with brake pads? How much to ship to Canada, T5Y 2T8? Thanks- sinkesho
- Post #63
- Forum: Official Group Buys
-
S
Little Bulbs?
RadioShack, #7219, 12V, 60mA (272-1092C InterTan) They look like LED’s, have pig tails, you need to pry your old bulbs out of their sockets.- sinkesho
- Post #15
- Forum: Gen 1 & 2 - Electronics & Audio
-
S
Cheap idler pulley came today!
Ishodu, you are probably right. You seem to know more about bearings that I do. You are right about sealed bearing being a better choice. However, I could not find a bearing so slim with rubber seals at a time. All I know is that this has lasted for about 27,000 km with no increase in noise...- sinkesho
- Post #20
- Forum: Gen 1 & 2 - Engine, Exhaust, Drive Line & AC syste
-
S
Cheap idler pulley came today!
The bearing is built by NSK, and it is 20mm ID, 37mm OD, 9mm wide and it is double sheilded, since sealed bearing I could not find back than. As I said right now there is 3mm of bearing sticking out passed the pully since the stock bearing had same ID & OD, but it was 15mm wide. This was the...- sinkesho
- Post #18
- Forum: Gen 1 & 2 - Engine, Exhaust, Drive Line & AC syste
-
S
Cheap idler pulley came today!
In regards to the idler pully, I fixed mine last summer and 27,000km ago. I used 6904ZZ (belive it was NSK part number, not sure) You will need two of these bearings, press them in side by side, one will stick out about 3mm, since they are 9mm wide (each) and stock bearing was 15mm wide, and...- sinkesho
- Post #15
- Forum: Gen 1 & 2 - Engine, Exhaust, Drive Line & AC syste
-
S
Steering Problems
Hello and allow me to introduce myself. I am an owner of 1992 Red SHO MTX and I too had a same problem as what was described. This was after I changed my rack and pinion due to the external leak I had. After I had replaced it, it had a **** in steering (I must say that going fast through...- sinkesho
- Post #5
- Forum: Gen 1 & 2 - Suspension, Brake Systems, & Body
