Recent content by sho_boi
-
S
Clutch help!
be careful! Is that all the parts? Or when they get it apart are they going to find out you need a new flywheel because your old one won't match up? That happened to me when I got mine replaced at ford.... I would not go to ford, go for an aftermarket clutch .... I think all the parts including...- sho_boi
- Post #3
- Forum: Gen 1 & 2 - Engine, Exhaust, Drive Line & AC syste
-
S
Heater Core?
OK When I accelerate really hard and get the RPM's above say 4500, I notice that radiator fluid drips onto my gas pedal. Yesterday I did something stupid, and redlined my SHO in 1st, 2nd, and almost in 3rd, (I stopped giving it **** around 90 and slowed down) and then I noticed my foot was...- sho_boi
- Thread
- Replies: 3
- Forum: Gen 1 & 2 - Engine, Exhaust, Drive Line & AC syste
-
S
a/c blend door actuator, schmactuator
My AC is doing the same thing. I think that I need a new ACC box. I will try to get the air to come out the dash and it will go to defrost in the summer, and in the winter when I want defrost the heat will come out the dash. I also notice that mine tends to switch on its own when the fan is...- sho_boi
- Post #5
- Forum: Gen 1 & 2 - Electronics & Audio
-
S
loud noise in the rear
More than likely it is a loose strut support. You have a clunking sound when you hit bumps. I'll have to check, but I think you just need to tighten up bolts that hold the support bar in place.- sho_boi
- Post #3
- Forum: Gen 1 & 2 - Suspension, Brake Systems, & Body
-
S
SHO needs push start... please help!
I had a similar problem in my 89 sho, but it was the Starter module in the streering colum. It is not real easy to get to, but you need to take off the colum covering and you will see it on the left hand side directly oppisite of where the key goes in. Probably would have been easiers if I had...- sho_boi
- Post #5
- Forum: Gen 1 & 2 - Engine, Exhaust, Drive Line & AC syste
