Current visitors

Recent content by Normster

N
Still overheating after......

Just one thing do you know if the coolant is circulating ? cause I had this similar problem the coolant was staying in the block and not circulating, found out the culprit it was my heatercore had to replace it was blocked there. something else to consider, well good luck.
- Normster
- Post #15
- Jun 27, 2005
- Forum: Gen 1 & 2 - Engine, Exhaust, Drive Line & AC syste
N
Check Engine Light

I live in New bordeaux thats like next to Ville St-Laurent off of Hwy 15 and de Salaberry. Where do u live ? actually I saw one SHO today funny thing we were back to back at one point until I had to get off the highway it was green like mine Gen2 he had an exhaust system which looked to big...
- Normster
- Post #10
- May 24, 2005
- Forum: Gen 1 & 2 - Engine, Exhaust, Drive Line & AC syste
N
Check Engine Light

Montreal,Quebec
- Normster
- Post #8
- May 23, 2005
- Forum: Gen 1 & 2 - Engine, Exhaust, Drive Line & AC syste
N
Check Engine Light

Thanks guys, I will run the tests and yes it does look easy.
- Normster
- Post #6
- May 23, 2005
- Forum: Gen 1 & 2 - Engine, Exhaust, Drive Line & AC syste
N
Check Engine Light

Thanks for the welcome, but how do I check the codes ? do I have to buy a tester or go to the dealer ? Sorry if I sound like a newb just want to know I've never done that before. I just got my 93 SHO a month and a half ago I had some problems with it I'm finalizing the last repair needed for now.
- Normster
- Post #4
- May 23, 2005
- Forum: Gen 1 & 2 - Engine, Exhaust, Drive Line & AC syste
N
Check Engine Light

Hello everyone, I'm new here so no one knows me yet. I need some help. I get a check engine light when engine temperature reaches NORMAL until then no light. I recently went to the dealer to check my idle stalling and engine light, it was O2 sensor and ECG Valve, both replaced error codes have...
- Normster
- Thread
- May 23, 2005
- Replies: 10
- Forum: Gen 1 & 2 - Engine, Exhaust, Drive Line & AC syste
N
brakes out of proportion

Hey Guys, I just had the same problem on mine, rear right side inner pad was worn out to the metal, I had it check out and it was the slider pin that clogged up so its been cleaned and greased all is fine now BTW all the pads in the rear were like brand new but I replaced all of them since I had...
- Normster
- Post #21
- May 23, 2005
- Forum: Gen 1 & 2 - Suspension, Brake Systems, & Body