Recent content by mike96

  1. M

    cleared code 0401/drove 40miles??came back on AGAIN..

    (reset--been driving)....The sel has not come on so far 100miles (knock on wood)different driving cycles,no 0401 code ..Do U think i could run a function test obd11 to see if all scans good without muffing up test cycles,?& if so ,,suggest to take it in 4 inspection??
  2. M

    cleared code 0401/drove 40miles??came back on AGAIN..

    I was told you do not have to take the surge tank off to change the dpfe sensor?,it looks like to me you have to?..Why are people buying that part used??(price point).. The car had been sitting 4 awhile with reg unleaded in it ran it out,, been putting prem unleaded back in her ,that would...
  3. M

    cleared code 0401/drove 40miles??came back on AGAIN..

    The code ( 0401)came back after 40 miles (second time).the first couple of times code 1518 came out ,believe i fixed that (no code on that )... MY question is if i reset code 0401 (clear)go to my nc /inspection station no mil light on///will i pass inspection ,or does code reset clear...
  4. M

    IMRC cable broke?

    Thanks for the info & will remember to keep post related to the topic...
  5. M

    IMRC cable broke?

    New code 0401- Exhaust Gas Recirculation Flow Insufficient Detected ..What is scoop on that??
  6. M

    IMRC cable broke?

    Thanks 4 the info .I will clear the code again,&see what happens.I just want to get past the inspection and then spend time on lim cleaning..
  7. M

    IMRC cable broke?

    code came back>>& ses light disconnected battery ,unpluged imrc box, DIDNOT wire seconderys open...(they are stuck open intake manifold runners)(code1518)i thought it was.After 20 miles computer learns itself the light & code comes back on ???Is this because i did not wire open ///...
  8. M

    IMRC cable broke?

    thanks to all the responses ,I did buy a new imrc box,i guess ,i will do as previously stated & in the near future tear the top end down & clean the butterflies and get back:thumb: that small bottom end back again...
  9. M

    IMRC cable broke?

    Thanks 4 the info..I think my butterflies are stuck open .I suppose, i disconnect IMRC and run the vehicle for a 75-100 mile cycle ,see if code pops up and all pcm functions are complete for emmisions for inspections at station.Sounds like ,i will have to tear down top end to clean butterflies ??
  10. M

    IMRC cable broke?

    Would like to say hello to all..New IMRC box,butterfies are stuck open,could some one tell me if i can clean them with out taking down top end,if so //how??(i have had problems ,emmision inspection sticker disconnect ,reset code ,worried after enough drive cycles passing for inspection in nc...
Back
Top