Current visitors

Recent content by KyleCim

K
Help the newbie thread.....

yea im able to do it and i was going to put in new struts for that fact that i dont wanna go back in again. So along w/the springs and struts im gonna have to get strut mounts (both front and back?) and strut bearings? Also, what would be the best/cheapest place to pick up the mounts and...
- KyleCim
- Post #11
- Feb 16, 2005
- Forum: Gen 1 & 2 - Suspension, Brakes & Body
K
Help the newbie thread.....

If the front actually sagged then id leave it as is lol but i got the lowrider look goin w/ zero wheel to fender gap in the rear and 2+ inches up front. And im cheapin out because i allways get myself in over my head...i have 2 other cars ( a 90 Mustang 5.0 and an 87 buick Grand national) But...
- KyleCim
- Post #7
- Feb 16, 2005
- Forum: Gen 1 & 2 - Suspension, Brakes & Body
K
Help the newbie thread.....

well me bein a cheapass i do understand the prob w/the struts but i also do want to lower the car. Just going by previous setups, i mean i have eibach's on my mustang w/stock struts and its been like that for over 5 years w/no problems...are these cars that much different that i will blow a non...
- KyleCim
- Post #4
- Feb 16, 2005
- Forum: Gen 1 & 2 - Suspension, Brakes & Body
K
Help the newbie thread.....

ok guys, im picking up an 95 mtx and it sags in the rear a good amount. Now im currently in school and have to pay this car off and i have a limited amount of funds and i have been looking at the intrax springs. What is the BARE minimum that needs to be done on a spring swap. To be perfectly...
- KyleCim
- Thread
- Feb 16, 2005
- Replies: 12
- Forum: Gen 1 & 2 - Suspension, Brakes & Body