Recent content by forddealertech
-
F
95 MTX-hard start after hot soak
Just replaced valve cover gaskets, intake gaskets, plugs & wires. Starts & runs fantastic now cold. Still has the hot soak hard start issue-had it before the above was replaced. Has new CKP, fuel pump less than 2 years old. also has the running with no tach issue-suspecting the CMP. Haven't...- forddealertech
- Thread
- Replies: 3
- Forum: Gen 1 & 2 - Engine, Exhaust, Drive Line & AC syste
-
F
Oil in plug wells
Yep--shop rag & long flat screwdriver works wonders. What's left, when starting, is a good mosquito killer on a hot day outside with no wind. The blue cloud has a good five minute hang time & will not harm your SHO!- forddealertech
- Post #6
- Forum: Gen 1 & 2 - Engine, Exhaust, Drive Line & AC syste
-
F
95 sho mtx rolling idle on decel...
Checked the grounds-repaired G103 at left inner fender-poor repair previously-possibly when clutch replaced. All intake clamps tight-zip tube tight.It idles around 1900 now. I'll clean the MAF & reinspect the IAC gasket--this just started after I cleaned the throttle body. I'm going to...- forddealertech
- Post #5
- Forum: Gen 1 & 2 - Engine, Exhaust, Drive Line & AC syste
-
F
95 sho mtx rolling idle on decel...
On decel-push in clutch & idle rolls 1100-1800 rpms,up & down-up & down. Release clutch & smooths out to about 1500 rpms. Push clutch in & continues until car stopped,at which point steadys at 1500 rpms. Does the same on up- shifts. Zip tube sealed. Swapped out IAC- still no change. This...- forddealertech
- Thread
- Replies: 4
- Forum: Gen 1 & 2 - Engine, Exhaust, Drive Line & AC syste
