Recent content by fat berger
-
F
CAMshaft identification sensor (CID) replacement
yeah i didn't go buy one..but I was just saying, that the whole fact that they change between english and metric is just ridiculous and they should just use one :) So don't get me started!!! haha jk- fat berger
- Post #8
- Forum: Gen 1 & 2 - Engine, Exhaust, Drive Line & AC syste
-
F
CAMshaft identification sensor (CID) replacement
Don't get me started about the 5.5mm socket!!! At any rate, after replacing the CID, my car still stummbles and needs to be started again. Non the less it usually takes 2 or three times to start. Do I need to rest anything or could it possibly be another part gone bad? I was thinking it could be...- fat berger
- Post #6
- Forum: Gen 1 & 2 - Engine, Exhaust, Drive Line & AC syste
-
F
CAMshaft identification sensor (CID) replacement
I need to replace the CID sensor due to a stumbling/hard starting problem, the only problem is I cannot find where it is located. If anyone could help me pin point where this is located I would really appreciate the help. advTHANKSance fat berger- fat berger
- Thread
- Replies: 7
- Forum: Gen 1 & 2 - Engine, Exhaust, Drive Line & AC syste
