802SHO's latest activity
-
802SHO replied to the thread 802SHO 2010 Build.Frank, I think you were absolutely on the right track Looking closer through the channels, you can actually see the PCM actively in... -
-
Andrew is there a table that shows scheduled torque? That sounds like a good place to start. If the schedule table is keeping torque...
-
802SHO replied to the thread 802SHO 2010 Build.Take a look at the initial throttle closure changes, pedal state, and timestamps. Before this section of the log, I was around 40 mph...
-
-
802SHO replied to the thread 802SHO 2010 Build.I shared that DA info to Ryan because I think it absolutely matters here. Finally had time to dig into the WOT log a little more and...
-
-
802SHO replied to the thread 802SHO 2010 Build.Funny realization after reviewing the logs and sending them to Ryan. I am basically tuning this car in near sea level conditions here...
-
Pretty much this. It's got more load in reverse over first gear to make it move. It's mostly a trick I learned from a transmission...
-
802SHO replied to the thread 802SHO 2010 Build.Thanks man! Yeah I think they are! No codes after that too.
-
-
Nice man, your diligence and patients are paying off. Hopefully all the electrical gremlins are in the rearview.
-
802SHO replied to the thread 802SHO 2010 Build.Quick follow up after last night’s test session. Alignment still needs one more pass, but it is vastly improved already. Steering wheel...
-
802SHO replied to the thread 802SHO 2010 Build.Understanding my Gyraline body measurements now. The last measurement 0.3 toe in both wheels but a perfect center thrust angle was...
-
802SHO replied to the thread 802SHO 2010 Build.The weather is actually fantastic tomorrow as well so today somehow I didn’t get to driving the car. Part shop work and part...
-
-
802SHO replied to the thread 802SHO 2010 Build.Could very well be.
-
I'm not disagreeing about stalling the torque converter to raise the fluid temp. I do it myself, 1500 rpm for 15-20 seconds at a time...
-
802SHO replied to the thread 802SHO 2010 Build.Also my observations with my trans temps idling where observed with no reservations as far as what it was supposed to do other than...
-
802SHO replied to the thread 802SHO 2010 Build.Idk good question. Maybe it doesn’t. Maybe it does. I tend to think absolute too much when I agree with something. How I explained it...
