Where do these connectors go? 95 mtx

Discussion in 'Gen 1 & 2 - Emergency Issues - Help & Maintenance' started by henthcr, Sep 11, 2017.

  1. henthcr

    henthcr SHO Member

    Joined:
    Sep 1, 2014
    Messages:
    9
    Likes Received:
    1
    Location:
    Wisconsin
    I am reassembling my sho after removing the subframe to replace the transmission, well like an idiot, I unplugged everything and didnt label everything, now it wont start and I cant find where these go.
    the first one is by the windshield wiper motor. the second one was just hanging under the car when I took everything apart. the third is on the wire with the eec test connector. and the last is on the antilock brake test line.
    any help would be great
     
  2. henthcr

    henthcr SHO Member

    Joined:
    Sep 1, 2014
    Messages:
    9
    Likes Received:
    1
    Location:
    Wisconsin
    so if anyone sees this and is also confused by something similar , i figured out that the third one is something something a/c clutch and i had it grounded oddly, it is on the front of the a/c compressor, and the 4th one is a ground connector for the testing block. the first two are still mysteries to me.
     
    SHOdded likes this.
  3. kevinspann

    kevinspann 87 Octane

    Joined:
    Sep 30, 2007
    Messages:
    3,095
    Likes Received:
    1,808
    Location:
    Richmond VA
    Is the first one the plug that goes into the brake reservoir cap for the low fluid sensor? If not, it may be "nothing".

    The second looks like the temp sensor that screws into the heater core hard pipe (if you still have it). The temp sensor is for the auto climate control and wouldn't effect engine running.

    Three, you're spot on, that goes to the AC compressor to power the compressor clutch.

    Four, glad you found it because I couldn't identify that.
     
    SHOCH, henthcr and SHOdded like this.

Share This Page

If you wish to help keep SHOforum running, please click the donation button below