Need chain sprocket for engine balance shaft, anyone have one?

In trying to remove the chain sprocket from my engine balance shaft, I broke a tooth. I later used heat and it came right off. It is a double row sprocket, and I "think" it would probably work with one compromised tooth, but I don't want to risk it. Does anyone have laying around?

Thanks,
Kyle

 

Double sprocket? Is this a Gen3 or Gen1-2?

 

1997, double row sprocket.

 

Alternatively, you could provide the sprocket to a company to have them make you a new one. There may not be an off the shelf product, but many smaller shops will make it to your specifications or even use the part you have to develop a new one. I don't have any experience with any companies, just a thought if you want NOS.

 

Does anyone know if this sprocket is the same one found on the Duratec motor?

 

I have two spare motors

 

Just to be clear, this is the sprocket you are referring too?

 

That is the one. I knew they were unavailable, but I suspected someone here would have one. What do you want for it?

 

I have two junk motors

 

Would you pull one off?

 

Is it pressed in ? Or just bolted in

 

Initially I thought it was pressed on, and I tried to use a puller. After damaging a tooth, I heated it with a propane torch and it came right off.

 

dont lose the keyway it's a tiny rectangle

 

Any luck?

 

No I had to finish my cat I’ve been busy