95' ATX temp sensor and sender location

Discussion in 'Gen 1 & 2 - Emergency Issues - Help & Maintenance' started by Jan Fiuczek, Mar 26, 2019.

  1. Jan Fiuczek

    Jan Fiuczek New Member

    Joined:
    Aug 8, 2018
    Messages:
    5
    Likes Received:
    0
    Gender:
    Male
    Location:
    Lodz, Poland
    Hello, could you please tell me where the temperature sensor and sender are located?
    There are so many hoses, plugs and wires under the hood that I couldn't find those yesterday (it was dark, so...)
    I want to place an order for the new ones and have to check their measurements first.
    Thanks
     
  2. BaySHO Performance

    BaySHO Performance SHO Member

    Joined:
    Feb 25, 2001
    Messages:
    195
    Likes Received:
    162
    Location:
    SF South Bay
    Home Page:
    Temp Sender for the gauge is behind the coil pack with a single wire coming off it. ECT Sender: two housings at the back of the motor. The front housing contains the thermostat. The rear housing is joined to the front housing by a short, wide rubber hose. The ECT sender is in the rear housing.
     
    SHOdded and Jan Fiuczek like this.
  3. NoSlo

    NoSlo GoldMember

    Joined:
    Aug 21, 2003
    Messages:
    407
    Likes Received:
    143
    Location:
    Portland, OR
    Home Page:
    Here's a pic of most of the cooling hoses and parts. This diagram is just short of actually having the electrical sensors noted:
    [​IMG]
    I had to replace the yellow one once...
     
    SHOdded likes this.

Share This Page

If you wish to help keep SHOforum running, please click the donation button below