Code: 162262517148352649 Your code expires on March 14, 2021, 12:00 Midnight CT.
Not intending to throw cold water on your plans in any way, but rather to share a simple fact about the factory configuration, the alternator that...
Or a ground wire from the strut tower ground stud to either one of the lower DIS mounting screws.
Put a thin coat of RTV around the perimeter of the seal or else it can leak at the seam in the housing (even the rubber coated seals). Use grease...
Attempting to replace the front part of the water pump, leaving the housing in place, frequently results in a leak because the tiny seal on the...
ebay is the best bet. It took months of watching, but I snagged a NOS Motorcraft from a seller out of Puerto Rico of all places. Cost me a...
If you're on a budget, the Walker 17906 with the factory resonator sounds good, but not loud. If you cut the stock muffler off leaving its inlet...
Since you've ruled out many logical things, that leaves only out of the box things to check. I like rubydist's thought of the timing belt being...
You can check exhaust system back pressure with a gauge that taps into the 02 sensor bung. Are your fuel injectors the correct ones? We're...
The fan runs when the either the coolant temperature is high or the A/C is on, whenever the car is moving at less than 50 mph. If it's working in...
Since you've hit most everything else, perhaps an exhaust system restriction?
If I may, the SHO camshaft sensor is called the Cylinder Indentification Sensor, or CID. The crankshaft sensor is called the Profile Ignition...
I suggest getting a Lithium Ion jump pack, aka jump starter, to carry in the car for peace of mind until you get this sorted out. The cam sensor...
Me too, which is why I was thinking button head torx. However, button head stainless is available in hex drive too, if one prefers that to torx....
This: http://www.shonutperformance.com/ Click on Motor Mounts. The table lists the obsolete Ford part numbers. Click on the Performance link....
Thanks for posting the thread size. How about a torx drive button head instead?...
There is a good explanation of the DIS and the CPS operation in the SHO Engine Book. It is a hall effect device, which is the most common type....
This: [MEDIA]
The SHOnut video also includes a detailed, printed procedure that guides you step by step through the entire project. I actually used that more...
Update - Replacing the rack solved the issue. Somehow, we managed to snag a Motorcraft remanufactured rack from Rockauto; listed as last one....
If you wish to help keep SHOforum running, please click the donation button below
Separate names with a comma.
