I had the code 157 with the old MAF, so replaced with a new one and still get the code 157 along with the code 211 etc. Any ideas where to check...
Looking for some advice and troubleshooting from other fellow SHO Guru's. I have a 93 MTX 3.0, what happens is when stopping at a light or slowing...
Pin Connector View
Not the best view, but should help.
I believe this is what you are looking for.
Keep up the good work, nice job on the qtr patches!
Anyone have or know of a parts source for a clutch quadrant P/N E7FZ-7L583-A
93 MTX 3.0, just finished putting in the engine/trans. I was wondering if anyone knows what color are the wires in the harness for CELO Switch...
I ordered mine from Advance Autoparts, also used a discount code. Axle shipped to my house within 48 hrs.
Does anyone know of a good area to install or tee off the sender for an aftermarket manual temp guage for a 93 3.0?
Currently I have the MTX out of the vehicle for a clutch, I also noticed that it leaks at the case halves. I did see a procedure on Shophoenix on...
It took me a weekend to drop the frame assy W/engine&trans. Due to my sho never had the subframe bolt/nut recall, so I did the drilling in the...
Does anyone by chance have the P/N for the dowel pins for a 93 flywheel? I was able to get 2 of them out, the other one snapped.
Have cradle/engine tranny removed, front 60K complete, upper next. Just finished up the rod bearings and rear seal. Clutch, P.S pump, A/C...
FYI to anyone interested, according to the VIN# given it is a 3.2L.
Here is a place in Michigan called Specmo. Here is the link.
Perfect candidate for a HEMI CRATE ENGINE $$$$$$$$$$$$
Silicon spray works great also!
X2 on that one
If you wish to help keep SHOforum running,
please click the donation button below
Separate names with a comma.