Cobra bracket mod for 11.5 inch rotors - need pictures

Discussion in 'Gen 1 & 2 - Suspension, Brakes & Body' started by itwonder, Jan 6, 2017.

  1. itwonder

    itwonder SHO Member

    Joined:
    Dec 17, 2005
    Messages:
    1,799
    Likes Received:
    422
    Location:
    VA
    TheCrimsonTurdis likes this.
  2. zak

    zak SHO Member

    Joined:
    May 15, 2002
    Messages:
    1,290
    Likes Received:
    207
    Location:
    east of Hartford
    Home Page:
    Bob I have them on an old computer hard drive at home, would need to get the computer hooked up and running over the weekend, if someone has handy please post. From memory 0.7 inches directly upward on both sides (center to center).
     
    TheCrimsonTurdis likes this.
  3. kevinspann

    kevinspann 87 Octane

    Joined:
    Sep 30, 2007
    Messages:
    3,074
    Likes Received:
    1,796
    Location:
    Richmond VA
    0.7" up, but then the bracket needs to be milled flat and spacers or washers need to be used. This is because the location of the new holes is not an entirely flat area on the bracket.

    Baer used to sell (and maybe still does) brackets modified for 12" rotors (you would use redrilled or slotted Crown Victoria rotors). They also came with a spacer and were $74 each when I asked a few years ago.
     
    TheCrimsonTurdis likes this.
  4. SHO Continental

    SHO Continental Moderator Staff Member

    Joined:
    Nov 28, 2004
    Messages:
    2,111
    Likes Received:
    498
    Location:
    Northridge, Cali
    SHOdded likes this.

Share This Page

If you wish to help keep SHOforum running, please click the donation button below